These initial cleaning instructions are shipped with every board. Repeat these steps as necessary Installer’s Instructions for Initial Cleaning at Time of Installation Wipe the board in a circular motion to loosen marker residue. Moisten a clean, dry cloth with isopropyl alcohol. Simply erase Removing Permanent Marker Option 2 Write over the top of the permanent marker ink with a dry-erase marker. Remember to discard eraser if used with Low Odor markers. If Low Odor markers have been used, the surface can be completely cleaned by following the cleaning instructions above. CAUTION! The use of Low Odor markers may cause ghosting to occur. More thorough cleaning may be required if writing is left on the board for more than two days. Wipe dry with a clean cloth If your board is used daily, the cleaning should be performed at least 2-3 times a week.

Wipe board with a clean cloth moistened by a liquid markerboard cleaner or a solution of 50% water and 50% isopropyl alcohol. because they may remove the finish from the markerboard surface.Ĭleaning e3 CeramicSteel Markerboard Surface Do not use abrasive cleaners or solvent type cleaning solutions, such as Ketones (Acetone, MEK, etc.) lacquer thinner, nail polish remover, etc.

In the event a permanent marker is used, removal of markings may be attempted by using dry erase cleaner, or by writing over the marking with a dry erase marker and erasing with a markerboard eraser or soft cloth. Do not use permanent markers on markerboard surfaces.Dry the surface with a soft cloth prior to writing. This may be done with a soft cloth or sponge. Dirty erasers will leave ink residue on the surface.įor daily cleaning, or as needed, use a dry erase cleaner, or a non-abrasive household cleaner, such as glass cleaner. Remove dry-erase markings with a markerboard eraser or soft cloth as often as possible.

Steelcase eno board download